BORDEN INC CONSUMER PRODUCTS DIV -- KRYLON 1311 MATTE FINISH ACRYLIC COATING  -- 8010-00-280-1257
<pre>=====================  Product Identification  =====================

Product ID:KRYLON 1311 MATTE FINISH ACRYLIC COATING
MSDS Date:04/19/1989
FSC:8010
NIIN:00-280-1257
=== Responsible Party ===
Company Name:BORDEN INC CONSUMER PRODUCTS DIV
Address:180 EAST BROAD STREET
City:COLUMBUS
State:OH
ZIP:43215
Country:US
Info Phone Num:800-848-9400; 614-431-6600
Emergency Phone Num:614-431-6600
CAGE:LO104
=== Contractor Identification ===
Company Name:BORDEN INC CONSUMER PRODUCTS DIV
Address:180 EAST BROAD STREET
City:COLUMBUS
State:OH
ZIP:43215
Country:US
Phone:800-848-9400; 614-431-6600
CAGE:LO104
Company Name:KRYLON PRODUCTS
Address:31500 SOLON ROAD
Box:City:SOLON
State:OH
ZIP:44139
Country:US
Phone:800-832-2541/216-566-2917
CAGE:87187

=============  Composition/Information on Ingredients  =============

Ingred Name:TOLUENE  (SARA III)
CAS:108-88-3
RTECS #:XS5250000
Fraction by Wt: 38%
OSHA PEL:200 PPM/150 STEL
ACGIH TLV:50 PPM; 9293
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:METHYLENE CHLORIDE	(SARA III)
CAS:75-09-2
RTECS #:PA8050000
Fraction by Wt: 25%
OSHA PEL:500 PPM/C,1000; Z2
ACGIH TLV:50 PPM, A2; 9192
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:ACETONE  (SARA III)
CAS:67-64-1
RTECS #:AL3150000
Fraction by Wt: 11%
OSHA PEL:1000PPM
ACGIH TLV:750PPM/1000STEL;9293
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:PROPANE
CAS:74-98-6
RTECS #:TX2275000
Fraction by Wt: 18%
OSHA PEL:1000 PPM
ACGIH TLV:ASPHYXIANT; 9192

Ingred Name:ACRYLIC ESTER RESIN
Fraction by Wt: 7%

=====================  Hazards Identification  =====================

Effects of Overexposure:INH:LIGHT HEADEDNESS, SLIGHT DIZZINESS, GROGGY,
    HEADACHE.

=======================  First Aid Measures  =======================

First Aid:INH:REMOVE TO FRESH AIR. EYES:FLUSH WITH WATER FOR 15
    MINUTES.

=====================  Fire Fighting Measures  =====================

Extinguishing Media:IN CASE OF FIRE, USE DRY CHEMICAL, FOAM OR CO*2.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
    EQUIPMENT . WATER MAY BE INEFFECTIVE, BUT SHOULD BE USED TO KEEP
    FIRE-EXPOSED CONTAINERS COOL.
Unusual Fire/Explosion Hazard:EXTREMELY FLAMM. DO NOT INCIN(BURN)
    CNTNR. AVOID HEAT. KEEP CNTNR <120F. HIGH TEMPS MAY CAUSE BURSTING.
    DO NOT PLACE CNTNR ON RADIATOR, STOVE, IN DIRECT(SUPDAT)

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE SOURCES OF IGNITION. SOAK UP W/
    ABSORBENT MATERIAL. VENTILATE AREA. MATERIAL NOT DANGEROUS WHEN
    SOLVENTS HAVE EVAPORATED TO DRYNESS.

======================	Handling and Storage  ======================

Handling and Storage Precautions:DO NOT STORE AT TEMOP >120F DO NOT
    PUNCTURE; CONTENTS UNDER PRESSURE (60LB/SQUARE INCH). DO NOT PUT IN
    DIRECT SUNLIGHT OR NEAR OTHER HEAT SOURCE.
Other Precautions:IF SPRAYED WITHIN 12 INCHES OF OPEN FLAME, SPRAY MAY
    CATCH FIRE AND BURN LIKE BLOWTORCH. TO EXTINGUISH FLAME, RELEASE
    SPRAY BUTTON. DO NOT BREATE FUMES OF BURNING SPRAY.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:ADEQUATE VENT PREFERRED. IF IMPOSSIBLE,USE
    NIOSH/MSHA APPRVD SCBA.
Ventilation:SUPPLEMENT NATURAL VENTILATION TO KEEP BELOW TLV.
Eye Protection:NOT MANDATORY
Supplemental Safety and Health
INGRED:SILICA GEL & CLAY COMBINED=1% OF PROD. BENZENE
    CONTAMINATION=<0.1% IN ANY COMPONENT. FL PT:FLAMMABLE COMPRESSED
    GAS. TLV FOR PROD:40 GRAMS/1000CUFT IS EST TO BE BELOW ACTUAL TLV.

==================  Physical/Chemical Properties  ==================

HCC:V3
Vapor Pres:60 PSIG
Vapor Density:HVR/AIR
Spec Gravity:LTR/WATER
Evaporation Rate &amp; Reference:>1 BUAC=1
Solubility in Water:SLIGHT
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:SUPDAT

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
NONE SPECIFIED BY MANUFACTURER.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:BIRNING SPRAY MAY PRODUCE TOXIC &
    IRRIT CHLORINE COMPOUNDS

====================  Disposal Considerations  ====================

Waste Disposal Methods:MFR RECOMMENDS WHEN DRY,DISCARD AS NON-DANGEROUS
    TRASH TO BE BURIED OR BURNED. DISPOSAL METHOD MUST BE IAW FEDERAL,
    STATE & LOCAL CODES. DO NOT INCINERATE CANS;CANS WILL BURST
    VIOLENLY.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.